Aerokleen A320 Gel

Product Description

Aerokleen A320 Gel is a heavy duty high viscosity aqueous based aircraft exterior cleaner.

  • Viscous high cling factor even when diluted
  • Slow drying is extremely important in hot weather conditions
  • High lubricity assists brush agitation over large area
  • Readily water dilutable for economic usage (25% in water)
  • Non streaking
  • Contains citrus based ingredients for increased performance
  • Completely biodegradable
  • Good rinsability
  • Comprehensive aircraft approvals

Aerokleen A320 Gel is a completely new concept in aircraft cleaning. The gel structure of the product enables it to continue to solubilise deposits without drying, even in adverse hot and windy weather conditions.

The unique structure of Aerokleen A320 Gel enables it to be readily applied through pressure applicators, whilst still ensuring that a substantial film of product clings to the surface. The structure of this film has also been specifically developed to offer high lubricity when agitated by brush.

Aerokleen A320 Gel was primarily developed for removing soils from landing gears, wheel wells and flap cavities. However, the product has also proved highly effective in the removal of the partially carbonized greases typically found in engine exhaust and thrust reverser areas.

Aerokleen A320 Gel was formulated to be readily dilutable in water whilst retaining a reasonable degree of viscosity. The product is, therefore, extremely versatile and equally suitable for use on all areas of the aircraft exterior.

Aerokleen A320 Gel incorporates naturally occurring citrus type additives in conjunction with the latest products of surfactant technology in order to boost cleaning performance without compromising on environmental acceptability.

Aerokleen A320 Gel contains no petroleum distillate solvents, is non flammable and presents no more of an effluent problem than conventional biodegradable water dilutable shampoos.

Aerokleen A320 Gel is fully biodegradable. The product is safe on aircraft materials, will not craze perspex and does not damage tarmac.

Please contact Aviation Spares & Repairs Limited for more information on the Aerokleen A320 Gel. We are here to help with all your GSE requirements.

  • Aerokleen A320 Gel may be applied by brush or pressure spraying equipment.

Heavy duty cleaning

  • For optimum performance on landing gear areas etc., Aerokleen A320 Gel should be used either as supplied or diluted at 50% with water. The product should preferably be applied to the areas by spray. After allowing a few minutes dwell time to enable the product to solubilise the soiling, the surface should be agitated by brush and then thoroughly rinsed.

General cleaning

  • For cleaning other areas of the aircraft exterior such as the upper fuselage, Aerokleen A320 Gel may be effectively used at a dilution of 25% in water, using the above method of application.

Immersion cleaning of aircraft wheels

  • Aerokleen A320 Gel used, as an immersion product will effectively wet out and remove the soils found on aircraft wheels. Rubber and heat baked contamination present no problem to this specialised product.
    The component, stator or aircraft wheel may be immersed in a tank containing neat Aerokleen A320 Gel. Its highly viscous characteristics allow the material to continue acting when the wheel has been removed from the tank and allowed to stand. Excess material should be allowed to drain back into the tank and a dwell time of approximately 15 minutes is recommended prior to water rinsing using an air/water gun. Light agitation with a brush may be beneficial.

Packaging

  • 25 litre and 200 litre drums, 1000 litre IBC’s and bulk road tankers

Health and safety information

  • Always consult the product label and Dasic Safety Data Sheet before use.